Use your AutoTap Express DIY to look for an RPM signal from the Crankshaft Position sensor while cranking the engine. If the problem is no spark, anything in the ignition circuit that creates the spark may be at fault.
#AUTOTAP EXPRESS DIY CRACKED#
This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap. Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. Then crank the engine to check for a spark. Autotap Registration - LS1TECH Many downloads like Autotap V3.1 may also include a serial number, cd key, keygen or crack. If it does then it will be found in the download file itself. Place the spark plug on a metal surface on the engine, or ground the spark plug tester to the engine. Autotap Express Diy Crack Serial Download Downloads like Autotap may often include a crack, keygen, serial number or activation code to make it the full version. Remove a plug wire and insert an old spark plug or a spark plug tester into the end of the wire (the plug boot). One may also ask, how do I fix no spark? If you do not see a spark, there is an ignition problem. This can happen while the vehicle is parked, or while you are driving. Eventually, the signal will weaken so much the signal will switch off, and so will the engine. Will a bad camshaft position sensor cause a car not to crank over? Answer: Normally it won't prevent current from reaching the starter, but it may 'disable' the ignition system - no spark.Īlso asked, what happens when a camshaft sensor goes bad?Īs the camshaft position sensor weakens, the signal it transmits to the vehicle's ECM also weakens.